Nitto - Flat Drive High Volume Oil Pump to suit RB20 / RB25 / RB25NEO / RB26 / RB30

***NITTO CRANK COLLAR REQUIRED FOR EARLY R32 GTR, ALL RB25 AND RB30 ENGINES***

The NITTO RB series high volume oil pump is a high quality performance aftermarket oil pump that will suit all Nissan RB engines. Oil flow and pressure is dramatically increased over that of the factory oil pump which is critical in modified engines for reliability of the lubrication system. Failure of this system is the “Achilles heel” of the Nissan RB series engine even on mildly tuned examples and accounts for a high percentage of ”RB” engine failures.

Factory based oil pumps are highly prone to oil pump gear failure in modified engines due mostly to the quality of the cheaper mass produced material used in the manufacturing of the OEM style gears. Oil pump gear failure will result with inevitable engine damage. For this reason EN Series billet steel material is utilised for the manufacture of NITTO RB series high volume oil pump gears which are far superior in strength and durability to that of both factory and its competitor’s oil pump gears.

NITTO utilizes their precision CNC machined cast alloy outer housing and along with their already proven oil pump design NITTO has now released a new billet alloy backing plate allowing further stability to oil pressure and flow at high rpm levels by minimizing any possible flexing of the housing.

NITTO RB series oil pumps are supplied pre-inspected, blue printed, assembled and cleaned to enable direct installation straight onto your engine and assure total confidence.

Suits the following engines:

• RB20
• RB25
• RB25 Neo
• RB26
• RB30

FLOW RATES (LITRES / MIN)

ENGINE RPM     FACTORY PUMP    NITTO HIGH VOLUME PUMP
750                      4.6                            6.5
2200                    15.3                          20.2
7000                    46.5                          64.8

PRESSURE RELIEF VALUE (RELEASE PRESSURE)

Dual Springs
120 psi *
Outer Spring Only
75 psi *

NITTO OIL PUMP GEAR VS FACTORY OIL PUMP

Outer Gear Diameter: 76.85MM vs 81.50MM (6% LARGER)

Outer Gear Width: 11.00MM vs 14.35MM (23% LARGER)

Tooth To Outer Wall Width: 2.55MM vs 4.85MM (47% LARGER)

Nitto Gears are made from Precision EDM Wire Cut EN Series Billet Steel and the Outer housing is a Precision Cast and CNC Machined Alloy coupled with a 7000 Series CNC Machined Billet Alloy Backing Plate.