Skip to content


GKtech - Offset Caster Rod Bush Inserts to suit R32 / R33 / R34

Original price $39.95 - Original price $39.95
Original price
$39.95 - $39.95
Current price $39.95


The GKTECH Billet Aluminium offset caster rod end inserts replace the inserts that go into the rose joint of your caster rod and give around 10mm more wheel clearance by moving the caster rod over. These are an easy DIY direct replacement that shouldn't take longer than 10-15 minutes to install.

- Machined from billet 7075-T6 aluminium and anodized for longevity

Vehicle Compatibility: (Provided the rose joint measures 19mm I.D and have a width of between 21-23mm)

- Nissan 180sx
- Nissan S13 Silvia
- Nissan S14 Silvia/200sx
- Nissan S15 Silvia/200sx
- Nissan Skyline R32 GTS-T
- Nissan Skyline R32 GTS4
- Nissan Skyline R33 GTS-T
- Nissan Skyline R33 GTS4
- Nissan Skyline R34 GT-T
- Nissan Cefiro A31
- Nissan Z32 300ZX


Will this fit my car? We can only confirm fitment for the vehicles listed above under "vehicle compatibility". If your car is not listed there, then we don't know if it will fit. They do fit many other caster rods, however, we can't test every caster rod that's ever been made. We can tell you that if the rose joint on your caster rod has an internal diameter of 19mm's and is 21-23mm's in width then these will fit. We do make complete caster arms which can be seen here for S13/180sx/R32/A31/Z32:, here for S14/S15/R33:

What's the advantage of using the GKTech offset caster rod bush inserts? The inserts move the position of your caster rod over around 10mm giving you more wheel clearance, as seen in the photo above this has moved the caster rod over enough that the wheel will now hit the swaybar before the caster rod.

What modifications are required, is this hard to fit? No modifications are required, simply just remove and refit.

Is there anything else needed for installation? No, you can use your OEM bolts. In terms of the inserts they will arrive as shown in the product photo.

Can I install this myself? If so how long will installation take? Yes, it is straightforward. Simply remove the one bolt holding the caster arm in, lower the arm, remove and refit our inserts the correct way. Installation time should be around 15 minutes.

Will I have to get a wheel alignment after installing these? These inserts will move the caster arm further inward, which will change your alignment. This will only be marginal, however when any suspension changes are made we do recommend a wheel alignment.